TeraTurtle LTO Tape 30 Capacity Case 07-039008

The Turtle TeraTurtle 30 LTO Tape Premium Waterproof/Dustproof Case 07-039008 has a capacity of up to 30 LTO tapes or data cartridges, with or without their individual plastic cases. TeraTurtle cases are designed for users who require dustproof and waterproof cases, but prefer not to use unsealed foam to hold the tapes in place. This design has a plastic guide, and any foam used on the top and bottom of the case is completely coated in a thin plastic film to prevent dust and foam from shedding during long-term use. The Teraturtle 30-capacity LTO tape case has stainless steel and plastic double-movement latches that prevent accidental opening for added protection. These Teraturtle 039 cases have options for two padlocks or security seals, which ensure there is no tampering with the contents. These TeraTurtle cases have a lifetime warranty.

Features:

• Waterproof
• Superior cushioning and no exposed foam or debris-generating agents
• Individual slots for each tape
• Dustproof
• ATA Impact certified
• Stainless steel hardware
• Double movement latches prevent accidental opening
• Double padlockable
• Lifetime warranty

Certifications 
Waterproof  IPX7
Dustproof  IP6X
Impact  ATA 300 
Drop Test  ASTM D-4169 CC-18
Vibration  STM D-4169 DC-18
Rainfall  ASTM D-4169 DCc-18 
Immersion  MIL-STD-810F

Descriptions of Tests 
ATA Specification 300 Category 1
Airline transport container suitable for a minimum of 100 airline trips
Impact Resistance Test; samples were exposed to impact using a bar weighing 13.2lbs with a hemispherical end of 3.2cm. The bar was dropped with its longitudinal axis vertical onto each sample’s weakest point from a height of 0.5m. Samples were conditioned at -20°C before impact exposure.

ASTM D-4169 DC-18
Level 1 Schedule A Handling (Manual)
Drop tests - a series of drops on each edge, corner and face of the case from a height of no less than 48cm(19”) and with loads of 6.8-31.8kg(15-70lbs) determined by case size. Samples were conditioned at ambient lab conditions and then at -28°C and +60°C for a minimum of 3 hours at each temperature.

ASTM D-4169 DC-18
Level 1, Schedule F loose load vibration
Vibration - The cases are tested using test method D-999 to determine the ability to withstand the repetitive shocks that occur during the transportation of loose loads.

ASTM D-4169 DC-18
Level 1, Schedule H Environmental Hazard Rainfall
Simulated rainfall for 2 hours at a rate of 10cm/hr (4”). Samples were conditioned to -20 degrees C and +52 degrees C.

MIL-STD-810F
Method 512.4
Immersion - The case is submerged in a basin of water to a depth of 1 meter (3.28 ft) to the topmost part of the case for 30 minutes. The case is heated to 10 degrees F above the water temperature.
IP 67 ingress protection
6- Total protection from dust
7- Protected against the effects of immersion between 15cm (5.9”) and 1m (39.37”)